Lightwave setup

If you are seeking for help, this is the right place to ask!
Post Reply
Engram
Posts: 2
Joined: 11 Feb 2019, 20:39

Lightwave setup

Post by Engram » 11 Feb 2019, 21:04

Hello,
i'm trying to setup RenderPal for LW 2018.0-5.
Basically i need to set LWSN.exe path and Lightwave CFG files.
i can set LWSN.exe path into Renderer Management - Lightwave - Executables tab.
I cannot find a place where i can set CFG file's path, can someone help me on this ?

thanks
Paolo

User avatar
Shoran Support
RenderPal Team
Posts: 1199
Joined: 11 Apr 2008, 00:35
Location: Germany
Contact:

Re: Lightwave setup

Post by Shoran Support » 11 Feb 2019, 21:13

You can set the configuration directory in the render set when creating the job in RenderPal.

Engram
Posts: 2
Joined: 11 Feb 2019, 20:39

Re: Lightwave setup

Post by Engram » 11 Feb 2019, 21:27

Hello,
thank you, i tried it but it does not work.
I've put the path where CFG is in the "configuration directory" field, and i've put Z:\ in "project Directory" (this is my Content for Lightwave).
Node waits some seconds then gives "erroneous" Status and does not render.
Anything i should fix ?

Thanks again
Paolo
You do not have the required permissions to view the files attached to this post.

User avatar
Shoran Support
RenderPal Team
Posts: 1199
Joined: 11 Apr 2008, 00:35
Location: Germany
Contact:

Re: Lightwave setup

Post by Shoran Support » 11 Feb 2019, 21:31

Take a look at the job's event and output logs to see what LW is telling you.

Post Reply