Page 1 of 1

Impossible set the address of the RenderPal V2 Server

PostPosted: 05 Dec 2017, 09:01
by anion
I want to set the address of the RenderPal V2 Server
Code: Select all
"RenderPalCl.exe" -heartbeat:"192.168.1.4" -silent -quit

address is not recorded in "RenderPalCl.cfg"
If not use "-silent -quit" everything works

Useful command-line switches:
Code: Select all
This switch allows you to set the address of the RenderPal V2 Server to use for heartbeat sending. The syntax is as
follows:
    /heartbeat:<server>
    /heartbeat:”192.168.0.100”
<server> denotes the address of the RenderPal V2 Server. You can also specify a port (using the address:port syntax) if it differs from the default one.


RenderPal V2 2.15.0.2002